Two-boson interference, a fundamentally quantum effect, has been extensively studied with photons through the Hong-Ou-Mandel effect and observed with guided plasmons. Using two freely propagating surface plasmon polaritons (SPPs) interfering on a lossy beam splitter, we show that the presence of loss enables us to modify the reflection and transmission factors of the beam splitter, thus revealing quantum interference paths that do not exist in a lossless configuration.We investigate the two-plasmon interference on beam splitters with different sets of reflection and transmission factors. Through coincidence-detection measurements, we observe either coalescence or anti-coalescence of SPPs.The results show that losses can be viewed as a degree of freedom to control quantum processes.

The radiative heat transfer between two dielectrics can be strongly enhanced in the near field in the presence of surface phonon-polariton resonances. Nevertheless, the spectral mismatch between the surface modes supported by two dissimilar materials is responsible for a dramatic reduction of the radiative heat flux they exchange. In the present paper we study how the presence of a graphene sheet, deposited on the material supporting the surfacewave of lowest frequency, allows us to widely tune the radiative heat transfer, producing an amplification factor going up to one order of magnitude. By analyzing the Landauer energy transmission coefficients we demonstratethat this amplification results from the interplay between the delocalized plasmon supported by graphene and the surface polaritons of the two dielectrics. We finally show that the effect we highlight is robust with respect to the frequency mismatch, paving the way to an active tuning and amplification of near-field radiative heat transfer in different configurations.

Compact and fast detectors, for imaging and wireless communication applications, require efficient rectification of electromagnetic radiation with frequencies approaching 1 THz and modulation bandwidth up to a few tens of GHz. This can be obtained only by using a mature technology allowing monolithic integration of detectors with low-noise amplifiers. One of the best candidates is indium phosphide bipolar transistor (InP HBT) technology. In this work, we report on room temperature high sensitivity terahertz detection by InP double-heterojunction bipolar transistors (DHBTs) operating in a large frequency range (0.25–3.1 THz). The performances of the DHBTs as terahertz sensors for communications were evaluated showing the modulation bandwidth of investigated DHBTs close to 10 GHz.

We study the radiative heat transfer between multilayer structures made by a periodic repetition of a graphene sheet and a hexagonal boron nitride (hBN) slab. Surface plasmons in a monolayer graphene can couple withhyperbolic phonon polaritons in a single hBN film to form hybrid polaritons that can assist photon tunneling. For periodic multilayer graphene/hBN structures, the stacked metallic/dielectric array can give rise to a further effective hyperbolic behavior, in addition to the intrinsic natural hyperbolic behavior of hBN. The effective hyperbolicity can enable more hyperbolic polaritons that enhance the photon tunneling and hence the near-fieldheat transfer. However, the hybrid polaritons on the surface, i.e., surface plasmon-phonon polaritons, dominate the near-field heat transfer between multilayer structures when the topmost layer is graphene. The effectivehyperbolic regions can be well predicted by the effective medium theory (EMT), thought EMT fails to capture the hybrid surface polaritons and results in a heat transfer rate much lower compared to the exact calculation. The chemical potential of the graphene sheets can be tuned through electrical gating and results in an additional modulation of the heat transfer. We found that the near-field heat transfer between multilayer structures does not increase monotonously with the number of layers in the stack, which provides a way to control the heat transfer rate by the number of graphene layers in the multilayer structure. The results may benefit the applications of near-field energy harvesting and radiative cooling based on hybrid polaritons in two-dimensional materials.

Small-angle scattering is a powerful and popular technique for the characterization of the average structure of dense nanoparticle assemblies and aggregates. It is usually limited to not too big assemblies due to the limited q-range, and low enough concentrations to avoid interactions. A straightforward and quantitative analysis of the generally available scattered intensity – even for large assemblies, at high concentrations – at intermediate-q is detailed. It is based on the similarity in local structure between infinitely large homogeneous assemblies of hard spheres or moderately sticky hard spheres with any finite-sized nanoparticle assembly dominated by hard sphere interactions. The method provides information on the local volume fraction of particles. The approach is then extended to polydispersities up to 40%, using numerical simulations of hard spheres and mildly sticky hard spheres. As a result, a simple relationship between the observed structure factor minimum – termed the correlation hole – and the local volume fraction on the scale of neighboring particles, which is also linked to the coordination number, is given. This relationship shall be useful as a simple and efficient tool for the structural analysis of arbitrary aggregated colloidal systems. Finally, recent examples of filler structure in model and industrial polymer nanocomposites will be reviewed.

Polymer nanocomposites are mixtures of nanoparticles and polymer chains, where the filler particles are usually added to enhance mechanical properties, e.g. of car tire materials. Performance depends to a great extent on the structure of the filler, i.e. its dispersion state in the polymer matrix, which itself depends on mixing protocols, but also on the thermodynamics of the system. The latter can be tuned by performing either chemical surface modifications of the nanoparticles, or by playing with the mass and/or grafting properties of the polymer chains. Some straightforward ways to obtain information from small-angle scattering on the filler structure of nanocomposites will be presented. In particular, we recently developed a quantitative analysis of the scattered intensity in the intermediate q range. It is based on the similarity in local structure between infinitely large homogeneous assemblies of hard spheres or moderately sticky hard spheres with any finite-sized nanoparticle assembly dominated by hard sphere interactions. This method provides direct information on the local volume fraction of particles. It will then be applied to the impact of small molecules on the silica structure in nanocomposites close to industrial applications.Finally, a second issue for the mechanical response of nanocomposites relates to the polymer dynamics, which may also be governed by the filler dispersion. We will present first quasi-elastic neutron scattering results showing the impact of the aggregation state on the segmental dynamics of the same samples by means of incoherent neutron spin-echo.