alpha-Quartz-type gallium phosphate and representative compositions in the AlPO4-GaPO4 solid solution were studied by x-ray powder diffraction and absorption spectroscopy, Raman scattering, and by first-principles calculations up to pressures of close to 30 GPa. A phase transition to a metastable orthorhombic high-pressure phase along with some of the stable orthorhombic Cmcm CrVO4-type material is found to occur beginning at 9 GPa at 320 degrees C in GaPO4. In the case of the AlPO4-GaPO4 solid solution at room temperature, only the metastable orthorhombic phase was obtained above 10 GPa. The possible crystal structures of the high-pressure forms of GaPO4 were predicted from first-principles calculations and the evolutionary algorithm USPEX. A predicted orthorhombic structure with a Pmn2(1) space group with the gallium in sixfold and phosphorus in fourfold coordination was found to be in the best agreement with the combined experimental data from x-ray diffraction and absorption and Raman spectroscopy. This method is found to very powerful to better understand competition between different phase transition pathways at high pressure.

Conversion-type electrode materials show extremely interesting performance in terms of capacity, which is however usually associated with bad Coulombic efficiency. The latter is mainly the consequence of the relentless evolution of solid electrolyte interphase (SEI) formed and/or dissolved during conversion/back-conversion reactions on the continuously reshaping active material surface. The thorough comprehension of the dynamic processes occurring during cycling in a working electrochemical cell, such as solvation/desolvation of ionic species and formation/dissolution of the SEI at the electrode/electrolyte interface, is thus of utmost relevance in the study of electrochemical mechanism and performance of conversion-type electrode materials. Operando Fourier transform infrared (FTIR) spectroscopy, one of the methods of choice for the study of such phenomena, was applied to study the dynamic interfacial properties of NiSb2, a representative intermetallic conversion-type electrode material for Li batteries, during cycling in the presence of a commercial electrolyte based on LiPF6 dissolved in a mixture of ethylene carbonate (EC) and dimethyl carbonate (DMC). Using a specifically developed in situ ATR-IR electrochemical cell, it was possible to correlate the electrochemical processes to the ratio between solvent molecules associated with Li+ ions and free solvent molecules and thus to follow the dynamic evolution of the concentration of lithium in the electrolyte during cycling.

Single-walled carbon nanotubes (SWCNTs) are functionalized with copper hexacyanoferrate (CuHCF) nanoparticles and therefore constitutes promising solid substrates for the sorption of Cs+ ions from liquid effluents. The high mechanical resistance and large electrical conductivity of SWCNTs are associated to the ability of CuHCF nanoparticles to selectively complex Cs+ ions in order to achieve membrane-like buckypapers presenting high loading capacity of cesium. The materials are thoroughly characterized using electron microscopy, Raman scattering, X-ray photoelectron spectroscopy and thermogravimetric analyses. Cs sorption isotherms are plotted after liquid phase ionic chromatography of the Cs solutions before and after exposure to the materials. It is found that the total sorption capacity of the material reaches 230 mg.g-1, and that one third of the sorbed Cs (80 mg.g-1) is selectively complexed in the CuHCF nanoparticles grafted on SWCNTs. These high values open interesting perspectives in the integration of such materials in electrically driven devices for the controlled sorption and desorption of these ions.

AlPO4-17, known as the oxide with the highest negative thermal expansion (NTE), was studied under high pressure by angle-dispersive X-ray diffraction (XRD), mid- and far-infrared (IR) spectroscopy. Upon increasing pressure, the closure of the (P–O–Al) angle destabilizes the porous AlPO4-17 structure, which drives the amorphization process. On the basis of the decrease in intensity of the XRD lines and broadening of the IR modes, the material was found to begin to amorphize near 1 GPa. XRD, mid- and far-IR analysis evidenced pressure-induced framework softening and complete irreversible amorphization near 2.5 GPa corresponding to the collapse of the pores. The bulk modulus and its first pressure derivative (B0 = 31.2(5) GPa and B′0 = −10.1(3)) at ambient temperature were determined by fitting a third order Birch–Murnaghan equation of state (EOS) to the pressure–volume data. The material is extremely compressible and exhibits an elastic instability. Anomalous (negative) values of B′0 are very rare and have been observed previously for cyanides and metal–organic frameworks. Such an instability appears to be characteristic of materials, which exhibit strong NTE behavior and indicates a link between NTE and anomalous compressibility behavior. Mid-IR, far-IR, nuclear magnetic resonance, and pair distribution function analysis of the new amorphous form allow an amorphization mechanism to be proposed corresponding to a collapse of the structure around its pores retaining the columns built up of cancrinite cages and hexagonal prisms, based on alternating AlO4 and PO4 tetrahedra. An increase in coordination number of 10% of the Al atoms was observed. The pressure-induced amorphization in the strong NTE material AlPO4-17 opens the door to the development of new technological applications as crystal–amorphous nanocomposites with zero or specifically selected thermal expansion coefficients.

Chalcogenide glasses and more importantly their glass-ceramics counterparts have been an interesting but very peculiar class of thermoelectric materials, with inherently low thermal conductivity (< 0.3 W/m.K). In this study, we report on the fabrication of glasses in the ternary system Cu-As-Te (Cu_xAs_55-xTe₄₅ [5 ≤ x ≤ 20], Cu₁₅As_85-yTe_y [45 ≤ y ≤ 70], and Cu₂₀As_80-yTe_y [45 ≤ y ≤ 65]) by melt-quenching and subsequent spark plasma sintering treatment. Their thermal and structural properties have been studied by differential scanning calorimetry and Raman spectroscopy, leading to give insights into the structural evolution of the glassy matrix. Coupling this information with the analysis of their electrical transport properties allowed us to deepen further our understanding of the compositional effect on their thermoelectric properties, and indirectly how the evolution of their electronic band structure is at play. Despite exhibiting low ZT values by themselves, Cu-As-Te glasses may still be interesting candidates for thermoelectricity through partial crystallization for which knowing the relationship between composition and properties remains essential.