Chemical vapor deposition has proved to be successful in producing graphene samples on silicon carbide (SiC) homogeneous at the centimeter scale in terms of Hall conductance quantization. Here, we report on the realization of co-planar diffusive Al/ monolayer graphene/ Al junctions on the same graphene sheet, with separations between the electrodes down to 200 nm. Robust Josephson coupling has been measured for separations not larger than 300 nm. Transport properties are reproducible on different junctions and indicate that graphene on SiC substrates is a concrete candidate to provide scalability of hybrid Josephson graphene/superconductor devices.

Electrical transport (resistivity and Hall Effect) have been studied in silicon doped aluminum nitride (AlN) thick epitaxial layers from 250 K up to 1000 K. The investigated samples, grown by molecular beam epitaxy were characterized by n-type conduction with an ambient temperature free carrier concentration of about ~ 1 x 10^15 cm^3. The donor level, situated about 250 meV below the conduction band edge, was found to be responsible for the experimentally observed increase of free carrier concentration withtemperature. The temperature dependence of carrier mobility has been analyzed in the framework of a multimode scattering model. In the investigated samples the main scattering mechanism is supposed to be dislocation scattering.

We have found the possibility to probe the magnetic field-driven topological phase transition in HgTe-based transistors by measuring their Terahertz photoconductivity response. At the critical magnetic field to which zero-mode Landau levels cross, we have observed a pronounced photoconductivity peak independent on incident frequency and carrier concentration. Our results pave the way towards terahertz topological field effect transistors.

Influence of AlN thickness on AlGaN epilayer grown by MOCVD

The magnetoabsorption spectra in double HgTe/CdHgTe quantum wells (QWs) with normal and inverted band structures are investigated. The Landau levels in symmetric QWs with a rectangular potential profile are calculated based on the Kane 8 × 8 model. The presence of a tunnel-transparent barrier is shown to lead to the splitting of states and “doubling” of the main magnetoabsorption lines. At a QW width close to the critical one the presence of band inversion and the emergence of a gapless band structure, similar to bilayer graphene, are shown for a structure with a single QW. The shift of magnetoabsorption lines as the carrier concentration changes due to the persistent photoconductivity effect associated with a change in the potential profile because of trap charge exchange is detected. This opens up the possibility for controlling topological phase transitions in such structures.

We present the concept, the fabrication processes and the experimental results for materials and optics that can be used for terahertz field-effect transistor detector focal plane arrays. More specifically, we propose 3D printed arrays of a new type - diffractive multi-zone lenses of which the performance is superior to that of previously used mono-zone diffractive or refractive elements and evaluate them with GaN/AlGaN field-effect transistor terahertz detectors. Experiments performed in the 300-GHz atmospheric window show that the lens arrays offer both a good efficiency and good uniformity, and may improve the signal-to-noise ratio of the terahertz field-effect transistor detectors by more than one order of magnitude. In practice, we tested 3 × 12 lens linear arrays with printed circuit board THz detector arrays used in postal security scanners and observed significant signal-to-noise improvements. Our results clearly show that the proposed technology provides a way to produce cost-effective, reproducible, flat optics for large-size field-effect transistor THz-detector focal plane arrays.

Electromagnetic coils are ubiquitously used in the modern world in motors, antennas, etc. In many applications (magnetic field coil calibration and nuclear magnetic resonance spectroscopy and imaging) there is a strong need for a homogeneous magnetic field. In this paper, we propose a simple modelling based on serial Fourier decomposition allowing the determination of the electrical conductor distribution to make the magnetic field homogeneous. The method is valid both for plane and axisymmetric geometries. The method allows the retrieval of the classical configurations of saddle coil for the plane geometry and Helmholtz coil for the axisymmetric one. The method is generalized for any number of electrical conductors and brings the perspective of new homogeneous magnetic resonance imaging (MRI) coil configuration.